planter.scad

@@ -1,5 +1,5 @@
 // Diameter of the inside cylinder
-diameter = 63;
+diameter = 62;
 // Height of the inside cyliner
 height = 40;
 // Number of cuts / ridges around the planter
@@ -12,8 +12,6 @@ thickness = 3;
 bottom_roundness_percent = 85;
 // Optional wall mount plate, 0 is no plate and 100 makes the planter a half-circle
 wall_mount_percent = 30;
-// Top angle
-top_angle = 20;
 
 module _end_of_customizer() {}
 
@@ -113,27 +111,19 @@ module planter() {
     bottom();
 }
 
-// Planter with optional wall mount plate and angled top
+// Planter with optional wall mount plate
 //
 // If `wall_mount_percent` is 0, no plate, if 100, the planter is a half circle
-difference() {
+if(wall_mount_percent > 0) {
     full_diameter = (diameter + thickness * 2) + cut_depth * 2;
 
-    if(wall_mount_percent > 0) {
+    wall_x = full_diameter / 2 * (1 - wall_mount_percent / 100);
-        wall_x = full_diameter / 2 * (1 - wall_mount_percent / 100);
 
-        wall_depth = full_diameter * sqrt(1 - (1 - wall_mount_percent / 100)^2);
+    wall_depth = full_diameter * sqrt(1 - (1 - wall_mount_percent / 100)^2);
 
-        chop_off(wall_x, thickness) {
+    chop_off(wall_x, thickness) {
-            planter();
-        }
-    } else {
         planter();
     }
-
+} else {
-    // Angled top
+    planter();
-    translate([-diameter / 2, -full_diameter / 2, height])
-    rotate([0, top_angle, 0])
-    translate([-full_diameter / 2 + diameter / 2, 0, 0])
-    cube([full_diameter / cos(top_angle), full_diameter, full_diameter]);
 }