phone-stand-keychain.scad

@@ -1,72 +0,0 @@
-use <MCAD/boxes.scad>
-
-/* [Keychain] */
-
-// overall height
-height = 10;
-
-// length, increase if phone falls backwards
-length = 60;
-
-// thickness of the long piece
-thickness = 4.3;
-
-// diameter of the hole for the key ring
-hole_diameter = 4;
-
-fillet = 1;
-
-/* [Phone] */
-
-// angle between the phone and the horizontal, 90=vertical
-angle = 65;
-
-// the thickness of the phone, if this value is too small, it won't fit between the supports
-phone_thickness = 11.3;
-
-/* [Supports] */
-
-// the length the supports extend from the long piece
-supports_length = 6.6;
-
-// the thickness of the first support, in front of the phone
-support1_thickness = 7;
-
-// the thickness of the second support, behind the phone
-support2_thickness = 4.5;
-
-$fs = 0.1;
-
-// Polyfill for https://github.com/openscad/MCAD/pull/66
-module roundedCube_(size, radius, sidesonly) {
-    translate(size/2) roundedBox(size, radius, sidesonly);
-}
-
-module long_piece() {
-    translate([-thickness, 0, 0]) roundedCube_([thickness, length, height], fillet, false);
-}
-
-module phone() {
-    translate([0, 0, height]) rotate([angle, 0, 0]) translate([0, -10, -phone_thickness - support1_thickness]) cube([40, 80, phone_thickness]);
-}
-
-big_num = 50;
-
-module supports() {
-    cube_length_transverse = support1_thickness + phone_thickness + support2_thickness;
-    cube_length = cube_length_transverse / sin(angle);
-
-    difference() {
-        translate([-thickness/2, 0, 0]) roundedCube_([thickness/2 + supports_length, cube_length, height], fillet, false);
-        // cut out phone slot
-        phone();
-        // cut out back of support2
-        translate([0, 0, height]) rotate([angle, 0, 0]) translate([0, -10, -big_num - phone_thickness - support1_thickness - support2_thickness]) cube([big_num, big_num, big_num]);
-    }
-}
-
-long_piece();
-
-supports();
-
-%phone();